Support Contact:

Mighty Tracker provides professional tracking solutions for business clients as well as for individual applications.  As an affiliate firm of MightyGPS a GPS hardware leader since 2000, we are well established to support any off the shelf or custom hardware and software requirements.

 

Our guiding principle is to make our solutions simple to install and simple to operate and work with.

 

Contact Us
  • For all support enquires please contact David Rogers using the form below:
     

    Your email:

    Subject:

    Your message:

     

    3-1750 The Queensway, Suite 526, Toronto, ON, Canada M9C5H5

     

     

 

FAQ:

 

Q: Could we activate more than one for the same price?
A: Prices are per tracking unit


Q: Will this product work OK inside of a vehicle?

A: Yes. Click here to see good spots that you can place the unit on the vehicle.
 
Q: How strong is the magnet, if placed underneath a vehicle would it survive bumps and jolts?
A: Yes absolutely.
 
Q: Do you compete with other company's prices?
A: You will find our prices usually already beats others but if you find a better price then let us know and we can likely beat it.

Q: How many would have to be purchased for a discount?

A: We can apply discounts on any order of 5 or more. Please contact us for a volume quote.
 

Q: How do I Program the Global Asset Tracker GAT:

A: Here are the instruction for allowing programming of GAT. Please follow them completely and make sure all LED's are functioning as mentioned before calling in for programming.

Before you can start using the GAT the battery will need to be charged. The battery can be charged with the unit powered on or off. The power on switch is located on the side off the unit. The built in battery charger automatically charges the battery whenever you connect to the battery charger.

When you power on the unit 3 LED's will flash for about 1-2 seconds. At start-up the GAT will test memory, GPS module, GSM module and if SIM card is installed. The GAT cannot operate without SIM card installed.
 

The 5 LED's on the GAT have the following functions:

Yellow LED - This is the GSM status led.
The LED will be OFF when there is NO GSM signal.
The LED will be ON if the GSM module OK and has GSM signal or is in sleep mode (except basic and deep sleep mode).
If blinking the GSM module is in test mode. During diagnostic start-up the GSM led will flash.
 

Green led - This is the GPS status led.
If off the GPS module is powered down.
If on then the GPS module has power, but non-valid GPS location. If
blinking the GPS module has power and valid GPS location.
 

Red LED1 - This is the Battery status led.
If off and charger is connected then battery is fully charged.
If on then battery is charging.
 

Blue LED - This is the Park, Motion or status LED when Panic input is configured to pickup and hang up Voice call (Park or Motion function
can be configured using the configuration menu program).
If off the Park, Motion or 24H no movement detection is off.
If ON then Park, Motion or 24H no movement detection is on.
If flashing then Voice call active or Panic input activated.
 

Red LED2 - This is the low Battery status led.
If off then battery power OK.
If on then battery power is low.